Generally the water conditioner cleanup required for clean water damage is far less. All you have to do is completely dry out your home. After everything has dried, check for mold. By leaving all windows and doors open, your home will dry much more quickly.
With a putty knife, carefully scrape the remaining parts of the wax ring from the area. Clean the spot so that the new wax ring will be level. Place a new wax ring on the opening and replace the toilet. Bolt it back onto the floor, reconnect the water line repair supply tube and watch for leaks as the water is turned back on.
After you have the stems out you should be able to find the washer on the "inside" end. If it is nicked, torn or brittle it is likely the cause of your drip. Even if it looks brand new, go ahead and replace it. You've already come this far. You can get replacement washers at almost any hardware store. Sometimes you may want to replace the whole stem, especially if the handle end is stripped out. It's best to just take the stem with you to the store and see if you can match it up. Most Do It Yourself stores have replacement stems for many popular brands. If your valve has a center diverter valve to switch the waterfrom the tub spout to the shower head the same process applies. Many times it is easier to replace the diverter stem than to repair it. This really depends on the design of the stem.
Once you have disconnected the tank remove it from your work space. Do a thorough measurement of the remaining pipe for reference when you go to the hardware store. I will be honest with you, you might need to make a few trips back to the store. Once you get the new tank, slide it into place to line up the plumbing.
The water line repair most likely damaged your electrical outlets and lighting fixtures. Have a qualified electrician come in to evaluate and repair the electrical.
Plumbers, contractors, landscapers, and related professionals are often indexed by numerous online websites eager for you to visit their "directory". Each field will have their own group of websites competing for your attention. In the end these "Plumbers Directories" are often incomplete, and frequently provide little more information than the phone book.
Then, you can take your new shower parts home and reinstall them in the inner assembly. It is very important that everything be aligned properly and tightened to prevent leaks. Beware of over tightening, however, since this can also cause problems. Once you are sure everything is installed properly, replace the cover plate and turn the water back on to test your repair work. With a little bit of work, your do-it-yourself shower repair project can be a success. It does not take an expert, just a little effort and know how.